GYP Plus

Super White Gypsum HomeSure Gyp+ is light weight gypsum based plaster suitable for application on most internal surfaces including brick, block and concrete. It consists of superior quality gypsum, formulated with special additives to enhance working and setting characteristics, also improves workability and coverage. When dry, it provides superior whiteness, smooth and matt finish and is suitable for all internal dry plastering applications.

  • Features
  • Advantages
  • Benefits
  • Other Details
  • Superior whiteness
  • Affordable
  • No shrinkage cracks
  • Excellent bonding
  • Light in weight
  • Imparts high coverage
  • Zero maintenance

Not Applicable.

  • Faster setting than the conventional sand cement plaster
  • Reduce structural load on building as it is 50% lighter than sand cement plaster
  • Direct application on Bricks, Blocks, RCC & Sand cement surface
  • No water curing required
  • Compatible with all types of paint and decorative range
  • Low consumption of paint

Not Applicable.

Application Procedure

Clean loose particles, dirt, grease and traces of adhering material from the wall surface with the help of sand paper, putty blade or by wire brush. Pre-wet the surface before application to achieve good workability and higher coverage.

Mix HomeSure Gyp+ to water and not water to powder. Water to plaster ratio should be (1 part of water and 1.5 part of HomeSure Gyp+ to be maintained to provide a good cohesive workable mix.) Mix HomeSure Gyp+ to water with the help of hand to form a uniform lump free paste. Install the wooden strip/dhada or install the levelling strip in the area where the paste needs to be applied. Apply the 1st coat approx. up to 8 mm to 10 mm of thickness, before the first coat sets rake and cross rake the surface. Fill in any hollow area, level off and compact the surface, then apply the final finish coat. After complete drying for usually 72 hrs.(Depending on the thickness and humidity), the plain smooth levelled surface i s ready for painting application.

Once the mix has begun to set, additional dry material should not be added, as performance properties of plaster will g et altered, thus affecting workability, cohesiveness, adhesion and strength. A single coat should not exceed more than 8 mm to 10 mm of thickness. If at all thickness required is more than 8 mm to 10 mm, then plaster needs to be applied in multiple coats. Use the material instantly after mixing. The surface on which the material needs to be applied should be levelled and pre-wet properly. HomeSure Gyp+ should not be applied on surface which is subjected continuous seepage or dampness.

Wear eye protection, impervious gloves and protective clothing. Advised to avoid direct eye and skin contact and recommended to keep it out of reach of children.

GYP + (Super white gypsum plaster) has a shelf life of 6 Months from the date of manufacturing if stored in a cool and dry location. (As temperature, humidity, water addition and other parameters vary from site to site; the above information should be treated as a general guideline).


Technical specifications

Technical Specification
ApplicationSuperior Whiteness
Pot life25 – 30 minutes
Initial Setting Time15 – 20 minutes
Coverage @ thickness of 10 mm.20 – 25 Sq. ft./Bag of 25 Kg

Not Applicable.